Metrohm 719 S Titrino - Manual (Página 92)

3.2. Remote control commands
719 S Titrino
88
3.2.2.66. Info.ActualInfo.Assembly.Counter.V read only
Info.ActualInfo.Assembly.Counter.Clear $G
$Q sends the volume. With the function &Info.Assembly.Counter.Clear $G, the
volume counter is set to zero.
3.2.2.67. Info.ActualInfo.Assembly.Meas read only
Info.ActualInfo.Assembly.PistonPos read only
$Q sends the current measured value from the assembly.
Piston position: 0 = initial position (filled)
10 000 = end position (empty)
3.2.2.68. Info.ActualInfo.Titrator.CyclNo read only
Info.ActualInfo.Titrator.V read only
Info.ActualInfo.Titrator.Meas read only
Info.ActualInfo.Titrator.dVdt read only
Info.ActualInfo.Titrator.dMeasdt read only
Info.ActualInfo.Titrator.dMeasdV read only
$Q sends the current values in the following formats:
SET MEAS CAL
CyclNo 127 127 127
V(ml) 1.2345
- -
Meas:
pH
U, Ipol (mV)
Upol (uA)
T (°C)
3.6(mV)
-345.6
-12.5
-
3.345
-345.6
-12.5
25.0
3.345
-
-
-
dVdt (ul/s) 2.5142 - -
dMeasdt
pH,U,Ipol mV/s
Upol (uA/s)
T (°C/s)
0.7957
0.7957
-
0.7957
0.7957
0.7957
0.7957
-
-
dMeasdV (mV/ul) 10.6326 - -
NV: Not Valid. If in the signal drift is OFF in modes MEAS and CAL, the signal
drift is NV.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.71). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.69. Info.ActualInfo.EP.Index read only
Info.ActualInfo.EP.X read only
Info.ActualInfo.EP.Y read only
.EP.X"1.234" Volume coordinate of the EP
.EP.Y"5.34" Measured value coordinate of the EP
3.2.2.70. Info.ActualInfo.Display.L1 up to 24 ASCII characters