Linksys SRW224G4P - Manual (Page 28)

Chapter  Configuring the Switch
24 24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
Event Descrpton A text comment that describes the
entry in the Event Setting Table .
Type The type of action that is taken for an alarm . This
can be None, Log, Trap, or Log and Trap .
Communty The SNMP community name that a trap
manager must use to receive trap messages .
Owner The name of the person who created this entry in
the Event Setting Table . (Maximum 127 characters) .
Click on the Add button to add an Event index entry to
the table .
To display each time an event was triggered by an alarm,
first highlight an entry in the Event Control Table and
then click on the Vew Log Table button . The Log Table
shows the log index number, the time of an event, and the
description of the event that activated the entry .
Statistics > Port Utilization
Statistics > Port Utilization
Displays the percentage of bandwidth currently utilized
on each port of the Switch .
Statistics > 802.1x Statistics
Statistics > 802 .1x Statistics
The Switch can display statistics for 802 .1X protocol
exchanges for any port .
To view the statistics for a port, select the required interface
from the drop-down menu and click Query .
To set a refresh rate for updating the 802 .1X statistics,
select a time interval from the Refresh Rate drop-down
menu .
ACL
Access Control Lists (ACL) provide packet filtering for IP
frames (based on address, protocol, Layer 4 protocol port
number or TCP control code) or any frames (based on MAC
address or Ethernet type) . To filter incoming packets, first
create an access list, add the required rules, specify a mask
to modify the precedence in which the rules are checked,
and then bind the list to a specific port .