Linksys SRW224G4P - Manual (Page 18)

Chapter  Configuring the Switch
14 24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
Chapter :
Confgurng the Swtch
Open your web browser and enter http://12.18.1.24
into the address field . Press the Enter key and the Password
screen will appear .
Address Bar
NOTE: The default IP address is 12.18.1.24 .
If the IP address has been changed using DHCP
or via the console interface, enter the assigned
IP address instead of the default .
The first time you open the web-based utility, enter
admn (the default username) in the username field and
leave the password blank . Click the OK button . You can
set a password later from the Admin tab’s User Accounts
screen .
Login Screen
Setup
The first screen displays the Summary screen on the Setup
tab . There are 10 tabs across the top of the screen: Setup,
Port management, VLAN Management, Statstcs, ACL,
Securty, QoS, Spannng Tree, Multcast, and a More
tab . Click the More tab to access the SNMP, Admn and
Logout tabs . Each tab contains screens that will help you
configure and manage the Switch .
Setup > Summary
The Setup > Summary screen displays a summary of
Switch information . The settings cannot be modified from
the Setup > Summary screen . Many of the settings can be
modified from the Setup > Network Settings screen .
Setup > Summary
Device Information
System Name Displays the name for the Switch, if one
has been entered .
IP Address The IP address assigned to the Switch is
displayed . (The default IP address is 12.18.1.24)
Subnet Mask The Subnet Mask assigned to the Switch is
displayed (The default is 2.2.2.0) .
DNS Servers The IP address of your ISP’s server, which
translates the names of websites into IP addresses .
Default Gateway IP address of the gateway router
between this device and management stations that exist
on other network segments . (Default: 0.0.0.0)
Address Mode Specifies whether IP functionality is
enabled via manual configuration (Static), Dynamic Host
Configuration Protocol (DHCP), or Boot Protocol (BOOTP) .
If DHCP/BOOTP is enabled, IP will not function until a
reply has been received from the server . Requests will be
broadcast periodically by the Switch for an IP address .
(DHCP/BOOTP values can include the IP address, subnet
mask, and default gateway .)
Base MAC Address The MAC address of the Switch is
displayed .