HP 3535 - Manual (Page 206)

5 – 6
Xerox DocuColor 3535 Printer/Copier
Transparencies
Transparencies can be fed from Trays 1- 5 (Bypass). Stripeless
transparencies are recommended. Striped transparencies must
be loaded in Trays 1 - 4 with the stripe face down, on the right side
of the tray. For Tray 5 (Bypass) striped transparencies must be
loaded with the stripe face up, on the left side of the tray.
NOTE: Use only the transparencies recommended in the
Recommended Materials for the DocuColor Series .
After loading the transparencies you can program the copier
printer to insert a blank separator page between transparencies by
using the Transparency Separators feature.
For more information about the Tranparency Separators feature,
refer to the section entitled
Transparency Separators , in this
chapter .
Follow these guidelines to prevent static build up when using
transparencies:
• Place no more than twenty 8.5x11 inch or A4 transparencies in
Tray 5 (Bypass) at one time.
• Place only one 11x17 in. or A3 transparency in Tray 5
(Bypass) at a time.
• Remove the transparencies from the Center Output Tray
before running additional sets.
• It is not recommended that you output more than 20
transparencies at a time. If your job is larger than 20 pages,
use the Transparency Separators feature.
NOTE: Transparencies cannot be delivered to the Finisher Tray.
For more specific information about materials that have been
tested and approved for use in the DocuColor 3535, refer to the
Recommended Materials for the DocuColor Series . Current
information is also available at the Xerox web site .