Reese 44535 PROFESSIONAL RECEIVER Manual del usuario

Installation instructions, Subaru b9 tribeca, Part numbers

Advertising
background image

Installation Instructions

Subaru B9 Tribeca

Part Numbers:

44535

75401

87407

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 11/16, 3/4

Drill Bits: None

1.

Lower the spare tire from the underside of the vehicle.

2.

Remove the two (2) plastic fascia tabs (do not discard).

3.

Using the 3/8 wire pull, insert the 3/8 Carriage bolts through the end of the inside portion of the vehicle bumper structure and

through the existing slots.

4.

Raise hitch into position and loosely install 3/8 Conical toothed washers and 3/8 Hex nuts as shown above.

5.

Using the ½ wire pull insert the ½ Carriage bolts and ¼ X 1.00 X 3.00 Blocks through the vertical holes in the vehicle frame

structure to the existing holes in the vehicle frame rails and through the receiver.

6.

Install ½ Conical toothed washers and ½ hex nuts.

7.

Tighten all fasteners to the required torque specifications.

8.

Reinstall the two (2) plastic fascia tabs removed in installation step 2.

9.

Raise spare tire back into position.

Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft.

Rev. B

01-24-06

75401N

Sheet 1 of 3

z

2005, 2006 Cequent Towing Products

½-13 X 2.00 GR5 Carriage Bolt

Qty. (2)

4

½ Hex Nut

Qty. (2)

7

3/8 Hex Nut

Qty. (2)

3

½ Conical Toothed Washer

Qty. (2)

6

3/8 Conical Toothed Washer

Qty. (2)

2

¼ X 1.00 X 3.00 Block

Qty. (2)

5

3/8-16 X 1.25 GR5 Carriage Bolt

Qty. (2)

1

Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 75401F or 87407F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

350

3500

Weight Carrying

Ball Mount

400

4000

Weight Distributing

Max Tongue

WT (LB)

Max Gross

Trailer WT (LB)

Hitch type

Wiring Access Location: SUV1, SUV2

Frame Structure

Bumper Structure

Fascia

Bumper Structure

Frame Structure

Spare Tire

Fasteners Typical Both Sides

Advertising