Reese 44537 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Kia Sedona Van
Hyundai Entourage
Part Numbers:
75421
44537
70761
78211
U-Haul
Do Not Exceed Lower of Towing Vehicle
Frame Rail
Fascia
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75421F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 4000 (1816 Kg) 400 (182 Kg)
Weight Carrying
Ball Mount
3500 (1589 Kg) 350 (159 Kg)
Wiring Access Location: SUV1 & SUV2
Wrenches: 19mm
Drill Bits: None
Frame rail
Existing
Weld nut
Fasteners typical both sides
1. Remove the exhaust from its hangers to get better access to frame fastener location.
1 Qty. (6) Hex Bolt M12 X 1.25 2 Qty. (6) Conical Washer
1. Remove the exhaust from its hangers to get better access to frame fastener location.
2. Raise hitch on the passenger side over exhaust pipe and slowly rotate hitch into position.
3. Secure hitch by loosely installing all the bolts.
4. Push hitch forward against installed bolts.
Tighten all m12 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
5. Reattach previously removed exhaust hangers.
z 2005, 2006, 2011 Cequent Performance Products Sheet 1 of 3 75421N 4-14-11 Rev. C
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.