Alpine IVA-W205 User Manual

Page 67

Advertising
background image

65

-EN

01GB06IVA-W205.fm

ALPINE IVA-W205 68-08564Z41-A (EN)

In Case of Difficulty

Basic

No function or display.
• Vehicle’s ignition is off.

- If connected according to the instructions, the unit will not

operate with the vehicle’s ignition off.

• Improper power lead connections.

- Check power lead connections.

• Blown fuse.

- Check the fuse on the battery lead of the unit; replace with the

proper value if necessary.

• Internal micro-computer malfunctioned due to interference

noise, etc.
- Press the RESET switch with a ballpoint pen or other pointed

article.

• Blackout mode is activated.

- Cancel Blackout mode.

No sound or unnatural sound.
• Incorrect setting of volume/balance/fader controls.

- Readjust the controls.

• Connections are not properly or securely made.

- Check the connections and firmly connect.

Screen not displayed.
• Brightness control is set at the minimum position.

- Adjust the Brightness control.

• Temperature in the vehicle is too low.

- Increase the vehicle’s interior temperature to operation

temperature range.

• Connections to the DVD, CD player, navigation system are not

securely made.
- Check the connections and firmly connect.

Movement of displayed picture is abnormal.
• Temperature in the vehicle is too high.

- Allow the vehicle’s interior temperature to cool.

Unclear or noisy display.
• Fluorescent plate is worn out.

- Replace the fluorescent plate.

Navigation system inoperative.
• Connections to the navigation system are incorrect.

- Check the connections with the navigation system and connect

the cables correctly and firmly.

The remote control is inoperative.
• The remote control sensor setting of “Rear Entertainment

Function” is not set to this unit.
- Set for this unit.

Unclear picture display.
• Fluorescent tube is exhausted.

- Replace the fluorescent tube*.

* The fluorescent tube replacement is not free of charge even within the

warranty period, for the tube is an article of consumption.

Radio

Unable to receive stations.
• No antenna, or open connection in the antenna cable.

- Make sure the antenna is properly connected; replace the

antenna or cable if necessary.

Unable to tune stations in the seek mode.
• You are in a weak signal area.

- Make sure the tuner is in DX mode.

• If the area you are in is a primary signal area, the antenna may

not be grounded and connected properly.
- Check your antenna connections; make sure the antenna is

properly grounded at its mounting location.

• The antenna may not be the proper length.

- Make sure the antenna is fully extended; if broken, replace the

antenna with a new one.

Broadcast is noisy.
• The antenna is not the proper length.

- Extend the antenna fully; replace it if it is broken.

• The antenna is poorly grounded.

- Make sure the antenna is grounded properly at its mounting

location.

• The station signal is weak and noisy.

- If above solution does not work, tune in another station.

CD/MP3/WMA/DVD/Video CD

Disc playback sound is wavering.
• Moisture condensation in the disc Module.

- Allow enough time for the condensation to evaporate (about 1

hour).

Disc insertion not possible.
• A disc is already in the DVD player.

- Eject the disc and remove it.

• The disc is being improperly inserted.

- Make sure the disc is being inserted following the instructions

in the CD/MP3/WMA, DVD/Video CD Player Operation
section.

Unable to fast forward or backward the disc.
• The disc has been damaged.

- Eject the disc and discard it; using a damaged disc in your unit

can cause damage to the mechanism.

Disc playback sound skips due to vibration.
• Improper mounting of the unit.

- Securely re-mount the unit.

• Disc is very dirty.

- Clean the disc.

• Disc has scratches.

- Change the disc.

• The pick-up lens is dirty.

- Do not use a commercially available lens cleaner disc. Consult

your nearest Alpine dealer.

Disc playback sound skips without vibration.
• Dirty or scratched disc.

- Clean the disc; damaged disc should be replaced.

CD-R/CD-RW playback not possible.
• Close session (finalization) has not been performed.

- Perform finalization and attempt playback again.

If you encounter a problem, please turn the power off, then on again.
If the unit is still not functioning normally, please review the items
in the following checklist. This guide will help you isolate the
problem if the unit is at fault. Otherwise, make sure the rest of your
system is properly connected, or then consult your authorized
Alpine dealer.

01GB00IVA-W205.book Page 65 Wednesday, January 24, 2007 5:11 PM

Advertising