Mabe Canada JGB918 - Manual (Page 11)

Oven Control, Clock and Timer Features
BAKE Pad
Touch this pad to select the bake function.
BROIL HI/LO Pad
Touch this pad to select the broil function.
Display
Shows the time of day, oven temperature,
whether the oven is in the bake, broil or
self-cleaning mode and the times set for
the timer or automatic oven operations.
On some models, it will also show warming
drawer settings.
If “F– and a number or letter” flash in the display and the
oven control signals, this indicates a function error code.
If your oven was set for a timed oven operation and
a power outage occurred, the clock and all programmed
functions must be reset.
The time of day will flash in the display when there has been
a power outage. Reset the clock.
If “Err” appears in the display, you have tried to set a time or
temperature outside of the control’s limits. Touch CLEAR/OFF
pad and enter a new setting.
On models with an oven door latch, if the function error
code appears during the self-cleaning cycle, check the oven
door latch. The latch handle may have been moved, even if
only slightly, from the latched position. Make sure the latch
is moved to the right as far as it will go.
Touch the CLEAR/OFF pad. Allow oven to cool for one hour.
Put oven back into operation. If function error code repeats,
disconnect power to range and call for service.
CLEAR/OFF Pad
Touch this pad to cancel ALL oven operations
except the clock and timer, and warming
drawer settings.
COOKING TIME Pad
Touch this pad and then touch the number
pads to set the amount of time you want your
food to cook. The oven will shut off when the
cooking time has run out.
DELAY START Pad
Use along with COOKING TIME or SELF CLEAN
pads to set the oven to start and stop
automatically at a time you set.
OVEN LIGHT Pad
Touch this pad to turn the oven light on
or off.
TIMER/CLOCK Pad
Touch this pad to select the timer feature.
Touch and hold this pad, until the display
changes, to set the clock.
START Pad
Must be touched to start any cooking or
cleaning function, and warming drawer settings
(on some models).
Number Pads
Use to set any function requiring numbers
such as time of day on the clock, timer, oven
temperature, internal food temperature, start
time and length of operation for timed
baking and self-cleaning.
WARMING DRAWER Pad (on some models)
Touch this pad and then touch number
pads 1–3 to use the warming drawer. See the
Using the electric warming drawer section.
SELF CLEAN Pad
Touch this pad to select self-cleaning
function. See the Using the self-cleaning
oven section.
Throughout this manual, features and appearance may vary from your model.
Using the oven controls.
(on some models) ge.com
(on models with number pads only)
11
Consumer Support
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips