Mabe Canada JGB918 - Manual (Page 16)

Not all features are on all models.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot
be changed during a timed baking or self-
cleaning cycle.
On models with a CLOCK pad,
touch it once to set. On models with
a TIMER/CLOCK pad, touch and hold
the pad until the display changes.
Touch the number pads.
Touch the number pads the same way you
read them. For example, to set 12:34, touch
the number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the CLOCK pad, the
display reverts to the original setting. If this
happens, touch the CLOCK pad and reenter
the time of day.
Touch the START pad until the time of
day shows in the display. This enters
the time and starts the clock.
To check the time of day when the display is
showing other information:
On models with a CLOCK pad, simply touch the
CLOCK pad.
On models with a TIMER/CLOCK pad, touch and
hold the TIMER/CLOCK pad until the time of day
is displayed.
The time of day shows until another pad is touched.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the KITCHEN TIMER ON/OFF
or TIMER/CLOCK (depending on
model) pad.
Touch the number pads until the
amount of time you want shows in the
display. The maximum time that can
be entered in minutes is 59. Times
more than 59 minutes should be
changed to hours and minutes. For
example, to enter 90 minutes as 1
hour 30 minutes, touch 1, 3 and 0 in
that order.
If you make a mistake, press the KITCHEN TIMER
ON/OFF or TIMER/CLOCK (depending on model)
pad and begin again.
Touch the START pad. After pressing
the START pad, SET disappears; this
tells you the time is counting down,
although the display does not change
until one minute has passed.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF or
TIMER/CLOCK (depending on
model) pad is touched.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of
a Timed Cycle.
Using the clock and timer.
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
16
Make sure the clock is set to the
correct time of day.
OR
HOLD 3 SEC. TO
SET CLOCK
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
OR
HOLD 3 SEC. TO
SET CLOCK
+