Installation instructions, Installation, Instructions – Mabe Canada JGB918 User Manual

Page 42: Installation range instructions, Before you begin, Important

Advertising
background image

BEFORE YOU BEGIN

Read these instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Canada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition and Canadian Gas Association according
to CAN/CGA-1.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow.
You will find these precautions in the Important Safety
Information
section in the front of this manual. Read
them carefully.

IMPORTANT –

Save these

instructions for local electrical inspector’s use.

IMPORTANT –

Observe all

governing codes and ordinances.

Note to Installer –

Leave these instructions

with the appliance after installation is completed.

Note to Consumer –

Keep this Owner’s

Manual and Installation Instructions for future
reference.

Note –

This appliance must be properly grounded.

Servicer –

The electrical diagram is in an envelope

attached to the back of the range.

• Skill level – Installation of this appliance requires

basic mechanical skills.

Proper installation is the responsibility of the

installer.

Product failure due to improper installation is not

covered under the Warranty.

Installation

Range

Instructions

Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of
this or any other appliance.

If you smell gas:

Open windows.

Don’t touch electrical switches.

Extinguish any open flame.

Immediately call your gas supplier.

FOR YOUR SAFETY

42

In the Commonwealth
of Massachusetts

This product must be installed by a licensed

plumber or gas fitter.

When using ball type gas shut-off valves, they shall

be the T-handle type.

A flexible gas connector, when used, must not

exceed 3 feet.

TOOLS YOU WILL NEED

Flat-blade screwdriver

Pipe wrenches (2)

(one for backup)

Phillips screwdriver

Open-end or

adjustable wrench

Pencil and ruler

Level

Advertising
This manual is related to the following products: