Troubleshooting – Maytag 27 Inch Electric Dryer Owners Guide Manual del usuario

Página 10

Advertising
background image

10

TROUBLESHOOTING

If you experience

Possible Causes

Solution

Cycle time too short

Sensor cycle ending early.

The load may not be contacting the sensor strips. Level the

dryer.

Use a timed dry for very small loads. Change the dryness level

setting on sensor cycles. Increasing or decreasing the dryness

level will change the amount of drying time in a cycle.

Lint on load

Lint screen clogged.

Lint screen should be cleaned before each load.

Stains on load or drum

Dryer fabric softener not properly

used.

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments. Drum stains are caused by dyes in clothing

(usually blue jeans). These will not transfer to other clothing.

Loads are wrinkled

Load not removed from dryer at the

end of the cycle.

Select Wrinkle Control cycle to tumble the load without heat to

avoid wrinkling.

Dryer tightly packed.

Dry smaller loads that can tumble freely to help prevent wrinkles

from forming.

Odors

You have recently been painting,

staining, or varnishing in the area

where your dryer is located.

If so, ventilate the area. When the odors or fumes are gone from

the area, rewash and dry the clothing.

The electric dryer is being used for

the first time.

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

Load is too hot

Laundry items removed from the

dryer before the end of the cycle.

Allow the dryer to finish the cool-down cycle before removing

laundry from dryer. All cycles are cooled slowly to reduce

wrinkling and make items easier to handle. Items removed

before cooldown may feel very warm.

A high temperature cycle was used

or the Temperature knob was set on

High.

Select a lower temperature, and use a sensor drying cycle.

These cycles sense the temperature or the moisture level in the

load and shut off when the load reaches the selected dryness.

This reduces overdrying.

First try the solutions suggested here or visit our website at

www.maytag.com/help

In Canada, visit

www.maytag.ca

for assistance and to possibly avoid a service call.

Advertising
Este manual se refiere a los siguientes productos: