Polk Audio DSW PRO 440wi - Manual (Page 6)

Downward Firing Dimensions
DSW PRO 440 WI : 13 3/4" W x 13 3/4" D x 14 5/8" H
(34.9cm W x 34.9cm D x 37.2cm H)
DSW PRO 550 WI : 15 1/2" W x 15 1/2" D x 16 1/8" H
(39.4cm W x 39.4cm D x 41.0cm H)
DSW PRO 660 WI : 16 1/2" W x 16 1/2" D x 17 1/8" H
(41.9cm W x 41.9cm D x 43.5cm H)
Forward Firing Dimensions
(height with rubber foot inserts)
DSW PRO 440 WI : 13 3/4" W x 13" D x 15 7/8" H
(34.9cm W x 33.0cm D x 40.3cm H
DSW PRO 550 WI : 15 1/2" W x 14 1/2" D x 17 5/8" H
(39.4cm W x 36.8cm D x 44.8cm H
DSW PRO 660 WI : 16 1/2" W x 15 1/2" D x 18 5/8" H
(41.9cm W x 39.4cm D x 47.3cm H
Note: Optional grille adds to depth (sold seperately).
AC POWER CONNECTION AND AUTO ON/OFF
Dual Voltage Switch
Wireless-ready subwoofers are equipped with either a dual
voltage switch or an auto sensor.
DSW PRO 440 WI
Auto Sense
DSW PRO 550 WI
Selectable
DSW PRO 660 WI
Selectable
WARNING: The correct voltage for your country has been set
at the factory. Only use the voltage setting specified for your
country. Using an improper setting may damage your subwoofer.
Main Power Switch
Turn power on/off via the AC MAIN switch.
Standby/Auto/On Switch
Your wireless-ready subwoofer uses a 3-position power switch, which selects
your subwoofer’s operational mode. The three modes are: Standby, Auto and On.
Standby
With the switch in this position, the subwoofer will only turn on (become active)
when the user presses the power button on the remote control. Once active the
subwoofer will remain on regardless of whether an audio signal is present.
Auto
Note: Wired connections only.
In the “Auto” position, your subwoofer automatically turns on when it senses
an audio signal and the LED located on the back of the subwoofer will be green.
When no signal is present, the subwoofer will enter a “waiting” state after 10
minutes and the LED will turn yellow.
We recommend the “Auto” mode if your subwoofer is always receiving
power (i.e., if it's plugged into a wall outlet).
On
The subwoofer is always on and fully active in this mode. The LED on the back of
the subwoofer will be green. This mode is best if the subwoofer is plugged into a
switched power outlet. The remote control cannot be used to turn off the sub-
woofer.
Note: You may want to leave your subwoofer unplugged or the AC MAIN
switch turned off during extended periods of non use, such as during a vacation
and also during electrical storms.
Power Mode LED Colors And Their Meaning:
Green:
Fully active
Yellow: Standby
Red: Protection
H
W D
H
W D
6
Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)