Sena Bluetooth SPH10H v4.2 User's Guide - Manual (Página 33)

SPH10H
33
Español
20. REINICIALIZACIÓN TRAS UN
FALLO
When the SPH10H is not working properly or is in a
faulty status for any reason, you may reset the system
by pushing the pin-hole reset button on the back of the
left headset main unit.
1. Detach the velcro pad inside of the left headset to see
a set-screw on the main module under the ear flap.
2. Turn the set-screw to the left to take the module apart
from the ear flap.
3. Take out the module from the front of the ear flap to
see the reset pin-hole on the opposite side of the
module.
Separar
4. Insert a paper clip into the reset pin-hole and press
the reset button for 1 second with light pressure, at
which time the SPH10H will be switched off. Turn
the SPH10H back on. By powering back on, this will
restore your current settings.