Delta PROFIBUS-DP Module for VFD Series Drives PD-01 - Manual (Page 11)

PD-01 PROFIBUS-DP Module
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 8
Insert the connector into the PROFIBUS-DP Interface (DB9), and tighten screws to
secure the connector in place.
Power Supply
The power of PD-01 is supplied from VFD series Drive. Firmware version should
conform the VFD series Drives as table listed in the page 2. No external power
needed. The +15VDC power is applied to PD-01 directly via a specific 6-PIN
communication cable (This 6-PIN cable is packed together with PD-01).
NOTE:
Though the PD-01 power is supplied from VFD series Drives, it will energized till power to
VFD series Drives is applied
1 6
1: +15V 2: GND
3: SG- 4: SG+
5: not used 6: not used
RJ11
Not used
+15V
GND
SG-
SG+