Pro Series 51076 51 Receiver Manual del usuario
Installation instructions, Hyundai santa fe, Part numbers
Installation Instructions
Hyundai Santa Fe
Part Numbers:
51076
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 16mm
Drill Bits: None
1.
Raise hitch into position.
2.
Install M10 X 1.25 bolts 7/16 lockwasher and 3/16 X 1.00 X 2.00 Blocks into existing weldnuts inside vehicle frame rails.
Rev. A
10-9-07
51076N
Sheet 1 of 3
z
2007 Cequent Towing Products
7/16 Lockwasher
Qty. (4)
2
3/16 X 1.00 X 2.00 Block
Qty. (4)
3
M10 X 1.25 X 30mm CL10.9
Qty. (4)
1
Tighten all M10 X 1.25 CL10.9 fasteners with torque wrench to 71 Lb.-Ft. (96 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51076F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
350
3500
Weight Carrying
Ball Mount
Not For Use With Spring Bars
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV3, SUV4
Frame Rail
Exhaust
Existing
weldnuts
Fascia