Pro Series 51139 51 Receiver - Manual

Installation Instructions
Honda Ridgeline
Part Numbers:
51139
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 10mm, 17mm, 19mm
Drill Bits: None
1. Lower the exhaust and remove the muffler heat shield.
2. Raise the hitch into position as shown.
3. Install the six (6) M12 fasteners into the frame rails and the two (2) M10 fasteners into the bumper structure as shown.
4. Re-install the heat shield and the exhaust.
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N.*M)
Rev. A 8-11-09 51139N Sheet 1 of 3 z 2009 Cequent Performance Products
Conical Toothed Washer 7/16” Qty. (2) 4 Conical Toothed Washer ½” Qty. (6) 2
Hex Bolt M10 x 1.25 x 30mm CL8.8 Qty. (2) 3 Hex Bolt M12 x 1.25 x 35mm CL8.8 Qty. (6) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle
and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Fastener Kit: 51139F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg.) 5000 (2270 Kg.)
Weight Carrying
Ball Mount
600 (272 Kg.) 6000 (2724 Kg.) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU1, PU2
Form: F205 Rev A 5-6-05
Bumper Structure
Fascia
Existing Weldnuts
12
43
21