Warning – Bosch SHE4AM User Manual

Page 13

Advertising
background image

13

OPERATING THE:

To start unit:

- Door must be closed. press the on/off button to turn the unit on.
- Program LEDs will be flashing to indicate “pre-select” mode.
- press

or

to select desired cycle.

- If desired press “Delay start” to select 3/6/9 hour delayed start. If desired press the Half Load option (SHE4AM1 models only)
- Press start to begin cycle. Program select LED stops flashing and Active LED illuminates.

NOTE: Rinse Agent LED will be illuminated if unit needs rinse agent.

Child Lock

- after pressing start you can activate the Child lock feature.
- press and hold

until "Child lock" leD illuminates. leD goes off once you release the button. Child lock is activated. now

any button you press (except on/off) will not function and the child lock leD will illuminate each time to indicate this

- to deactivate: press and hold

until the child lock leD goes out.

WARNING

You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during
any wash or rinse cycle. Do not fully open the door until water noises have stopped.

To cancel cycle:
NOTE: Child lock needs to be deactivated

- Press and hold the “Start Reset “ button for 3 seconds.
the unit will drain any remaining water ( takes about 1 minute), active leD goes out and Clean leD illuminates.
- turn unit off.

Setting Options (Extra Dry Heat / Rinse Agent Amount)

- Door must be closed. turn unit on.
- Wash cycle LED will be flashing to indicate pre-select mode.
- To enter “setup” mode press and hold

then press and release “Start Reset” button; then release

.

- Clean and one other LED will be flashing to indicate setup mode.

-

press

to select an option (extra Dry Heat / rinse agent amount)

- press to adjust the setting for the respective option.

to set extra Dry Heat: Clean & Sanitized LED flashing

power scrub

Heat setting
extra Dry on

extra Dry off


- press to switch between the Heat and rinse agent options.
- press start to save

to set rinse agent amount: Clean + Rinse Agent LED flashing

SHE4AM1

SHE4AM0

sHe4aM1

sHe4aM0

power

scrub

regular

Wash

Quick

Wash

rinse &

Hold

rinse aid

setting

power

scrub

auto

Wash

regular

Wash

Quick

Wash

0
1

2

3

Advertising
This manual is related to the following products: