Network connection, Twisted-pair cable – Asus E2915 User Manual

Page 45

Advertising
background image

45

Using the Notebook PC

4

WARNING! Only use analog telephone outlets. The built-in modem does not support

the voltage used in digital phone systems. Do not connect the RJ-11 to digital phone

systems found in many commercial buildings or else damage will occur!

Example of the Notebook PC connected to a Network Hub or Switch for use with the built-in

Ethernet controller.

Network Connection

Connect a network cable, with RJ-45 connectors on each end, to the modem/network port on the Note-

book PC and the other end to a hub or switch. For 100 BASE-TX / 1000 BASE-T speeds, your network

cable must be category 5 or better (not category 3) with twisted-pair wiring. If you plan on running the

interface at 100/1000Mbps, it must be connected to a 100 BASE-TX / 1000 BASE-T hub (not a BASE-T4

hub). For 10Base-T, use category 3, 4, or 5 twisted-pair wiring. 10/100 Mbps Full-Duplex is supported

on this Notebook PC but requires connection to a network switching hub with “duplex” enabled. The

software default is to use the fastest setting so no user-intervention is required.

1000BASE-T (or Gigabit) is only supported on selected models.

Twisted-Pair Cable

The cable used to connect the Ethernet card to a host (generally a Hub or Switch)

is called a straight-through Twisted Pair Ethernet (TPE). The end connectors are

called RJ-45 connectors, which are not compatible with RJ-11 telephone connectors.

If connecting two computers together without a hub in between, a crossover LAN

cable is required (Fast-Ethernet model). (Gigabit models support auto-crossover so

a crossover LAN cable is optional.)

OFF

ON

EXPRESS

Network Hub or Switch

Network cable with RJ-45 connectors

LAN

connector is the

larger of the two�

Advertising
This manual is related to the following products: