American Audio CDI-300 - Manual (Page 21)

© American Audio ® - www.AmericanAudio.us - CDI-300™ Instruction Manual Page 21
BASIC OPERATIONS (CONT.)
16. RECALL FLASH MEMORY:
The CDI-300 can store all your user programmed cue points in to memory. These
cue points may be recalled at any time, even when a disc has been removed and
reinserted at a later time. To recall the memory on a specific disc; 1) Be sure a
CD is not loaded in to the drive. 2) Press the MEMORY BUTTON (13) down until
the red memory LED turns on. 3) Insert the CD. "RECALL" will appear in the LCD
(21) while the memory is being installed and the red MEMORY BUTTON (13) LED
will turn off.
18. FIRMWARE VERSION DISPLAY:
You may display the units firmware version. Firmware is the units internal programming code. To view the firm-
ware version; While main power is turned off, turn the SEARCH KNOB (21) in a clockwise direction. While the
search knob is turned in a clockwise direction turn main power on. The firmware version will appear in the LCD
(22), as long as the search knob is held in the clockwise position.
17. CLEAR ALL MEMORY:
You may clear the system memory at any time. This will erase all your programmed memory and restore the
unit to it's default settings. To clear the memory; While main power is turned off, turn the SEARCH KNOB (20)
in a counter-clockwise direction. While the search knob is turned in a counter-clockwise direction turn main
power on. The LCD (22) will flash three times and default memory will be restored.
15. SYSTEM MEMORY:
The CDI-300 comes with an incredible memory system. The unit can memorize
all cue points, and samples used on a particular disc. To store all your setting
for a CD, press and hold down the MEMORY BUTTON (13) for at least three
seconds. When the memory has been stored properly the MEMORY LED (13)
will turn off. The memory is full the outline of the MEMORY BUCKET (31) in the
LCD (22) will disappear.
Figure 30
Figure 29
� � � � � � � � � � � � � � � � � � � �
� � � � � � � � � � � � � � � � � � � �