Before first use, Hob - daily use, 1 initial cleaning – AEG 47056VS-MN Benutzerhandbuch
Seite 7: 2 setting the time, 3 preheating, 1 heat setting
![background image](/manuals/30258/7/background.png)
3. BEFORE FIRST USE
WARNING!
Refer to "Safety information"
chapter.
3.1 Initial Cleaning
• Remove all accessories and removable
shelf supports (if applicable).
• Clean the appliance before first use.
Refer to the chapter "Care and
cleaning".
3.2 Setting the time
You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut, the
indicator for the Time of Day function
flashes.
Press the + or - button to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time, press
again and again until the indica-
tor for the Time of Day function
flashes. You must not set the Du-
ration
or End
function at
the same time.
To use the appliance, push the knob.
The knob comes out.
3.3 Preheating
Preheat the empty appliance to burn off
the remaining grease.
1.
Set the function
and the maxi-
mum temperature.
2.
Let the appliance operate for one
hour.
3.
Set the function
and the maxi-
mum temperature.
4.
Let the appliance operate for ten mi-
nutes.
5.
Set the function
and the maxi-
mum temperature.
6.
Let the appliance operate for ten mi-
nutes.
Accessories can become hotter than
usually. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
4. HOB - DAILY USE
WARNING!
Refer to "Safety information"
chapter.
4.1 Heat setting
Knob
Function
Keep Warm
0
Off position
Knob
Function
1-9
Heat settings
(1 - lowest heat setting, 9 -
highest heat setting)
1.
Turn the knob to a necessary heat
setting.
2.
To stop the cooking, turn the knob
to the 0 position.
Use the residual heat to decrease
energy consumption. Deactivate
the cooking zone approximately
ENGLISH
7