Automatic demonstration, How to attach the core filter, Y$ t – JVC GR-D21 User Manual
Page 6
EN
6
Automatic Demonstration takes place when
“DEMO MODE” is set to “ON” (factory-preset).
Ⅲ Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch
y
is set to “
” or “
”
and no cassette is in the camcorder.
Ⅲ Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
Ⅲ “DEMO MODE” remains “ON” even if the camcorder power is
turned off.
Ⅲ To cancel Automatic Demonstration:
1. Set the Power Switch
y
to “
” while pressing down the Lock
Button
t
located on the switch and press the MENU/VOLUME
wheel
$
in. The Menu Screen appears.
2. Rotate the MENU/VOLUME wheel
$
to select “
(SYSTEM)”
and press it.
3. Rotate the MENU/VOLUME wheel
$
to select “DEMO MODE”
and press it. The Sub Menu appears.
4. Rotate the MENU/VOLUME wheel
$
to select “OFF” and press
it.
5. Rotate the MENU/VOLUME wheel
$
to select “
RETURN”,
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
None
RETURN
OF F
ON
EMO MODE
D
–
S
Y
S
TEM
y
$
t
Sub Menu
Attach the Core Filter(s) (if provided with your model
੬
pg. 5) to an optional cable(s). The Core Filter reduces
interference.
HOW TO ATTACH THE CORE FILTER
1
2
3
Release the
stoppers on both
ends of the Core
Filter.
Run the cable through the Core Filter, leaving approx. 3 cm
of cable between the cable plug and the Core Filter. Wind
the cable once around the outside of the Core Filter as
shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder.
Ⅲ Be sure to use a cable with a thickness that will allow it to be wound around the core filter.
Wind once
GR-D31/21EK 01-10
02.12.19, 9:16 PM
6