Warning – Wayne-Dalton TORQUEMASTER 3663-372 User Manual

Page 35

Advertising
background image

28

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

To

Ope

ra

t

e

D

o

o

r

Press

Here

TO AVOID INJURY, NO ONE SHOULD
CROSS THE PATH OF A MOVING DOOR!

The profile routine automatically sets the
door open and close limits and calibrates
obstruction sensing. During the profile
routine, the door will move up and down
twice.

NOTE:

If an object such as a ceiling beam

obstructs the door from opening completely,
skip this step. Set a Custom Upper Limit, see
Step 25.

NOTE:

The door must be in its fully closed

position and the disconnect handle must
be in the motor operated position (upper
position) to initiate the profile routine.

NOTE:

Profile routine will not run if safety

sensors are not aligned (only if required
installation).

Press and hold the profile button for
five (5) seconds.
The opener will beep
twice, release the profile button, indicating
the activation of the profile routine. The door
will now move to the fully open position and
stop, beep twice and then the door will close
completely.

Next, the door will go through one more up/
down cycle. Once this is complete, the door
limits are set and the profile is complete.

NOTE: Upon successful completion proceed
to Step 26.

Profile Routine

(Standard Upper Limit)

Programming Light Fixture

Program Button

Light Button

Profile

Button

Tools Needed:

None

LED

WARNING

Press the red program button on the light
fixture. The LED on the light fixture will turn
on and remain on for 30 seconds
or until a opener is learned to the light
fixture. The incandescent lamp will also turn
on when program button is pushed.

Press the light button on the wall station.
This must be done within 30 seconds of
pressing the program button on the light
fixture. The light fixture lamp and LED will
blink three times to indicate successful
programming. The light fixture can now be
turned on and off from this wall station.

NOTE:

In order to program the opener to

the light fixture, the installer must have the
wall station already programmed to the
opener.

23

24

Tools Needed:

Step Ladder

PRE-OPERA

TION

Advertising