Viper 5902 - Manual (Page 53)

50 © 2009 Directed Electronics. All rights reserved.
Using the 1 way companion remote
The companion 1 way remote commands the system features as
shown in the previous table, but without the message display of the Re-
sponder HD remote. Siren chirps and vehicle parking light flashes are
used to indicate that a command has been received and activated as
described in the Basic and Advanced command sections.
Accessing Commands
Similar to the HD remote, Basic commands are performed when
a command button is pressed directly. To perform Advanced Com-
mands press the
button 1 to 4 times to access function levels, x4
in the table for example implies pressing 4 times. The LED flashes in
groups for a few seconds to indicate the level. Press the desired com-
mand button while the LED is flashing to perform the command.
Sensor Bypass operation
The lights flash each time this command is received to indicate the
Sensor bypass type. 2 flashes indicates sensor Warn-away zones
are bypassed, 3 flashes indicates sensor Warn-away and Full Trigger
zones are bypassed. 1 flash indicates sensor bypass is off.
Button Auto Lock
When On, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked, a
fault tone is emitted. To unlock the buttons; press the
button followed
by the button, the buttons unlock and tones play to confirm.
Car Select*
Car 2 must first be turned On (See Remote Features menu under the
following Programming section to turn on). Press and hold the but-