SENAO EnGenius EP-801 User Manual

Page 25

Advertising
background image


~49~

Call a Caller ID

1. Press

key, use

or

key to scrool the call log.

2. When display a caller ID, Press

or

to dial this number.


Base Speed Dial Setting


1. You can store up to 20 entries in the speed dial memory. Each speed

dial memory can contain a phone number (up to 32 digits).

2. Base during standby mode, press

key, enter the telephone

number.

3. Press

key, followed by a 2-digit memory location, base then will

emit a two short tone (Bi-Bi) to confirm the setting.

Re: The memory location is “00” ~ “19”.

4. When using the base speed dail, press

key followed by 2-digit

memory location (“00”~”19”), then press the

key

.

The base will dial the telephone number accordingly.


Base Ringer Setting


1. You can change the base ringer by following :

2. Base during standby mode, press

key twice, followed by

or

key, the base speaker will emit the varied ringer (up to 8

ringer tones).

3. Press

key to confirm the setting.

4. To adjust the ringer volume, two options can be followed:

a. Base during standby mode, press

or

key.

b. When incoming call, press

or

key.

c. When press

or

key to adjust the volume, the speaker will

emit the loudness of ringer, you can choose the preference.

Re: The loudness level of ringer is “0~4”, “0” means ringer “Off”.


~50~

Multi-Base Setting

“Multi-Base” setting allows expanding coverage or lining capacity. When
adding 2

nd

, 3

rd

or 4

th

base, using one of the handsets which registered to the

1

st

base (i.e. the handset with ID 11), followed by below processes:

1. Press

MENU

, followed by “7” to enter the registration

mode.

2. Press & hold the base REG button for thress seconds,

the base will emit the prompt ringing (also the base
speakerphone & Intercom LED is flashing).


3. Press digit “3” of handset to enter the Multi-Base

mode.

4. Select BS # 1

5. Repeat above step 1 ~ 4 to continuously add the 2

nd

,

3

rd

or 4

th

base.

Re:The base ID for 1

st

base is “10”, for 2

nd

base is

“20”, for 3

rd

base is “30”, for 4

th

base is “40”.

Notes:
1. When initial setting the “Multi-Base”, you have to select the BS #1

first, then followed the above steps to select 2

nd

, 3

rd

or 4

th

base.

2. For synchronization mechanism, all handsets must be register again

before start using multi-base scenario. i.e. the initial handset ID with
1x must register to BS1, and the rest handsets must be registered to
2

nd

, 3

rd

or 4

th

base respectively.

3. After all above processes, the “Multi-Base” is complete then.

Call Manager


“Call Manager” feature allows two options:

Advertising