SENAO EnGenius EP-801 - Manual (Page 15)

~29~
5. The base unit will page for 30 seconds, then terminate the page if no
handset responds.
6. Before a handset answers, the INTERCOM can only be cancelled from
the base by pressing again. However, once a handset answers,
the base and the answering handset both can end the call.
C. Intercom/2-Way from Handset to Base
1. Press key followed by the left softkey -- BASE
2. The base will ring, until press the key to connect
the intercom call with the handset.
Making a Broadcast
A. Handset to Handset Calls
1. Broadcasting all handsets
a.
Press and hold key (left side of handset) from
one handset.
b. Hear bi-bi-beep while the initiating handset
broadcast to all handsets within communication
coverage.
c. Start to speak the message to be broadcasted once you hear the
“beep” sound; the speakerphone of destination handsets will be
opened up.
d. Release key to end the broadcasting.
2. Broadcasting a group of handsets
a.
Enter the Group ID and then press and hold
key (left side of handset).
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage.
c. Start to speak the message to be broadcasted once you hear the
“beep” sound; the speakerphone of destination handsets will be
opened up.
d. Release key to end the broadcasting.
~30~
3. Broadcasting an individual handset
a. Enter the Handset ID and then press and hold
key (left side of handset).
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage.
c. Start to speak the message to be broadcasted once you hear the
“beep” sound; the speakerphone of destination handsets will be
opened up.
d. Release key to end the broadcasting.
B. Broadcasting from Base to Handset
1. Broadcasting to all handsets
a. Press key and hold for 3 seconds on the base
station to broadcast all registered handsets.
b. Hearing bi-bi-beep while initiating broadcast to all
handsets.
c. The BROADCAST LED will light up
d. Press the
key again and return to end the
broadcasting.
2. Broadcasting a group of handsets
a. Enter the Group ID then press key and hold
for 3 seconds.
b. Hearing bi-bi-beep while initiating broadcast to the
grouped handsets
c. The BROADCAST LED will light up
d. Press
key to end the broadcasting.
3. Broadcasting an individual handset
a. Enter the Group ID then press key and hold
for 3 seconds.
b. Hearing bi-bi-beep while initiating broadcast to the
grouped handsets
c. The BROADCAST LED will light up
d. Press key to end the broadcasting.
C. Broadcasting from Handset to Base
1. Broadcast to the base station
a. Enter the Base ID (10) and then press
key