Roland SP-555 - Manual (Page 54)

54
Appendix
✩ : The depth of these parameters will be limited if you turn on “Effect Limit mode” (p. 20).
*1: Delay time is specified as a note value relative to the tempo of the longest sample of the samples to which the effect is
being applied.
Note values that you can specify:
32nd note (t32) / 16th note (t16) / 8th note triplet (t8t) / dotted 16th note (t16.) / 8th note (t8) / quarter note triplet
(t4t) / dotted 8th note (t8.) / quarter note (t4) / half note triplet (t2t) / dotted quarter note (t4.) / half note (t2) / dotted
half note (t2.) / whole note (t1)
However, you can’t select a setting that would cause the delay time to exceed approximately 2000 milliseconds. If a
pattern is playing, the tempo of the pattern is used as the reference.
Effect list
Effects that you can select by directly pressing a button
Type CTRL 1 function (display) CTRL 2 function (display) CTRL 3 function (display)
SUPER FILTER CUTOFF (CoF) RESONANCE (rES) ✩ FILTER TYPE (LPF/HPF/bPF/ntF)
A filter with an extremely
steep slope (sharp attenua-
tion). (-36 dB/octave) Adjusts the cutoff frequency. Adjusts the amount of peak at the
cutoff frequency. Selects the type of filter. LPF: Passes
the frequency region below the cut-
off. HPF: Passes the frequency re-
gion above the cutoff. BPF: Passes
the frequency region around the cut-
off. NTF: Passes the frequency re-
gions other than the region near the
cutoff.
VOICE TRANS FORMANT (FrM) EFFECT LEVEL (EFF) DIRECT LEVEL (dir)
Processes a human voice to
create a variety of characters. Adjusts the character (formant) of
the voice. Adjusts the volume of the effect
sound. Adjusts the volume of the direct
sound.
DELAY DELAY TIME (t32–t1) *1 FEEDBACK (Fdb) ✩ BALANCE (bAL)
Repeats the sound. Adjusts the interval of the repeats. Adjusts the number of the repeats. Adjusts the volume balance be-
tween the direct sound and effect
sound.
ISOLATOR LOW (Lo) ✩ MID (Mid) ✩ HIGH (Hi) ✩
Isolates or removes the low,
mid, or high frequency rang-
es. Isolates/removes the low-frequency
range. Isolates/removes the mid-frequency
range. Isolates/removes the high-frequen-
cy range.
DJFX LOOPER LENGTH (LEn) ✩ SPEED (-1.0–1.0) LOOP SW (oFF/on)
Loops a short portion of the in-
put sound. You can vary the
playback direction and play-
back speed of the input sound
to add turntable-type effects. Specifies the length of the loop. Specifies the playback direction
and playback speed. Turning the
knob to the left of 12 o’clock pro-
duces backward playback, and
turning the knob to the right of 12
o’clock produces forward play-
back. At 12 o’clock, the playback is
stopped. If you turn this on while sound is
playing, the sound at that point will
be looped. Turn this off to cancel
the loop.
SP-555_e.book 54 ページ ２００７年６月２５日 月曜日 午前９時９分