Heading and position data – Raymarine Radar equipment Raychart Chartplotter RC530 PLUS User Manual

Page 25

Advertising
background image

Chapter 1: Overview

1-9

He

ad

in

g an

d P

osi

tio

n

Dat

a

He

ad

in

g an

d P

osi

tio

n

Dat

a

Heading and Position Data

Full functionality of the radar/chartplotter is achieved when it is part of an
integrated system with other equipment (in addition to another

hsb

2

unit)

connected via SeaTalk or NMEA 0183. Data from this equipment including
position and heading is shown on the display and is used in calculations.

Details on connecting other equipment are given in Chapter 8.

Providing Heading Data for Radar/Chart Overlay and MARPA

The performance of MARPA and Radar/Chart Overlay is dependent on the
quality of your heading sensor. It is important that both the heading sensor and
the radar scanner (bearing alignment) are correctly calibrated. Refer to the
appropriate heading sensor and radar scanner handbooks for calibration
details. The better the accuracy of your heading data, the better the
performance of MARPA and Radar/Chart Overlay.

A gyro compass provides the best performance in all conditions. Alternatively
you could use a fluxgate compass with rate gyro stabilization.
MARPA requires heading data to be frequently updated (we recommend a
data output rate of greater than 8 Hz); heading data must therefore be provided
on NMEA.
In multiple-display systems, heading must be connected, via NMEA, to each
display that will be used for MARPA.

We recommend the Raymarine Rate Gyro Compass system. Good results are
also obtained with a Raymarine autopilot system incorporating a 150G or
400G Course Computer with internal rate gyro.

Other heading sensors connected on NMEA may provide satisfactory results
in reasonable sea states. However, in unsettled conditions a rate gyro compass
is advisable.

Contact Raymarine Customer Services or your authorized Raymarine dealer
for additional information. For specific configuration details with the
Raymarine course computer refer to Appendix E. If you are using a suitable
third party heading sensor, refer to its documentation for installation and
calibration details.

Advertising