2 resetting the system – Raymarine Radar equipment Raychart Chartplotter RC530 PLUS User Manual

Page 213

Advertising
background image

Chapter 9: Maintenance and Problem Solving

9-3

Resetti

ng th

e System

9.2 Resetting the System

There are three types of reset available for the display:

Factory Reset: This resets all values back to their original factory settings.

CAUTION:
The factory reset clears the Marks database, and the chartplotter
Waypoints and Routes databases.

Power-On Reset: When you turn the display off and on again, the screen
reverts to the fishfinder or chart picture with all windows cleared.

Picture Reset: Press and hold the DISPLAY key for two seconds to return
the screen to the full-screen picture of the top window with all windows
cleared.

At power-on, the last-used values are retained for all the options, except for
those listed in the following table which are reset to the factory default each
time.

➤ To perform a factory reset:

1. Press MENU.

2. Press the SYSTEM SET UP soft key to display the System Set Up page (see

Section 7.3 for details).

3. Press and hold MENU for 5 seconds.

A countdown timer is displayed. If you release the MENU key before the
timer reaches zero, the reset is not performed.

When the reset request has been accepted, the system restarts.

The factory default settings are listed in Section 7.3

Table 9-1:

Power On Default Settings

Item

Power-on setting

Heading Mode
Rain
FTC
Alarm
Zoom
Windows
Brightness

Head Up (radar); North Up (chart)
OFF (but value stored) – radar only
OFF (but value stored) – radar only
ON, with last-used value
OFF
OFF
ON at 100%.

Advertising