2 changing the set up parameters, Radar, Chart – Raymarine Radar equipment Raychart Chartplotter RC530 PLUS User Manual

Page 160

Advertising
background image

7-2

hsb

2

PLUS Series Color LCD Display

Cha

ng

in

g the
Set U

p

Pa

ra

m

eters

7.2 Changing the Set Up Parameters

The set up parameters are divided into four sections:

System, to control the aspects of the system that are not specific to the
radar or chart.

Radar, includes bearing alignment, display preferences and the timed
transmission option.

MARPA, to control the MARPA target tracking parameters, including tar-
get vectors, safe zone and target history display.

Advanced, to control specialist radar settings such as display timing, STC
preset and tune preset (see Section 7.6 for instructions on how to access
these functions).

Chart, to control the chartplotter display, including waypoint information,
vectors and radar/chart synchronization.

Note: The GPS and Track Set Up menus are described in Chapter 6.

This section provides instructions for displaying and changing the default
values. The following sections list the parameters and their possible settings,
and describe the function of each parameter in turn.

➤ To set the default parameters:

1. Press the MENU key to display the set up soft keys - the options available

depend on the selected operating mode.

Radar

Chart

2. Press the soft key for the set up you require.

The requested set up menu is displayed, listing the parameters and their
current settings.

3. Use the trackpad to move the selection bar up and down the list. An arrow

is displayed at the top or bottom right-hand corner if you can scroll the list
to display further parameters.

As each line is highlighted, the soft keys are updated to show the settings
available.

MENU

D3640-3

SYSTEM

SET UP¬

RADAR

SET UP¬

MARPA

SET UP¬

D4162-1

SYSTEM

SET UP¬

CHART

SET UP¬

TRACK

SET UP¬

GPS

SETUP¬

Advertising