Radio Shack Univer 15-2138 - Manual (Page 25)

O
WNER
’
S
M
ANUAL
USING MACROS
The RadioShack 8-in-One Remote includes six macro keys: M1 through
M4, COM MUTE, and PWR. Each one can be set up to perform a repetitive,
time-consuming operation with the press of a single key.
NOTES : A macro programmed onto the PWR key can only be accessed in the MY
SYSTEM mode. Pressing it in any other mode will only send a “Power On/Off ”
IR command to the selected device. The COM MUTE key can be programmed as a
two-state rotating macro. See “Programming The COM MUTE Key” on page 27.
A macro can be used to control a home theater operation, to set a
favorite channel, or for other multiple functions you would like to control
with one key press. Moreover, each macro key can hold up to 15 key
presses total.
NOTE : Programming a new macro over an existing one will erase the
original macro.
P ROGRAMMING A F AVORITE C HANNEL M ACRO
With so many channels available on your cable or satellite system, you
can program a macro that directly selects a favorite channel with one
key press. For example, let’s assume your favorite cable programs are
on channel 71. Use the following instructions to program a macro for
direct access of this channel:
NOTE : The following example assumes all equipment is turned off and that the
TV is connected through the Cable Box with TV tuning set to channel 3.
1. Press and hold P until the bottom IR segment flashes twice.
The program keys will appear:
2. Press above MACRO once. The Macro programming screen will appear:
3. Press an open macro key (e.g., M1, M2, M3, or M4). The last-selected
device menu screen, including , will be displayed.
4. Enter a desired macro sequence of up to 15 key presses. For this
example, press TV once, followed by PWR once, and then enter 0 3 for
the TV’s channel number. Next, press CBL once, followed by PWR
once, and then enter 0 7 1 for the Cable Box’s channel number.
continued on next page...
Using Macros 25
RS 8in1 Kameleon OM rev 10/9/03 4:11 PM Page 25