Nuvo NV-E6DMS User Manual

Page 30

Advertising
background image

*********************************************************************************
COMMAND:

*ZxxVRSTON<CR> – zone xx VOLUME RESET ON.

RESPONSE:

Same response as for *ZxxSETSR<CR>

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

*********************************************************************************
COMMAND:

*ZxxVRSTOFF<CR> – zone xx VOLUME RESET OFF.

RESPONSE:

Same response as for *ZxxSETSR<CR>

NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.

*********************************************************************************
COMMAND:

*ZxxLKON<CR> – zone xx KEYPAD LOCK ON – This will INHIBIT ANY keypad control input on the zone.

This is the same as activating the Parental lock control at a keypad by holding down a SOURCE key for three seconds).

RESPONSE:

#ZxxLKON<CR>

*********************************************************************************
COMMAND:

*ZxxLKOFF<CR> – zone xx KEYPAD LOCK ON – This will RESTORE ALL keypad control input on the zone
(useful as Parental lock control) . This is the same as de-activating the Parental lock control at a keypad by

holding down a SOURCE key for three seconds).

RESPONSE:

#ZxxLKOFF<CR>

*********************************************************************************
COMMAND:

*VER<CR> – Firmware version query.

RESPONSE:

#NUVO_E6D_vx.yy<CR> where x is the major version number and yy

is the minor version number.

*********************************************************************************
RESPONSE:

#EXTMON<CR> Issued whenever the External MUTE first activates (closure to ground) and
0 whenever the External MUTE de-activates (open connection to ground).

NOTE – there is no COMMAND associated with this response; it is always initiated by a change at the EXT. MUTE input.

*********************************************************************************
RESPONSE:

#EXTMOFF<CR> Issued whenever External MUTE de-activates (open connection to ground).

NOTE – there is no COMMAND associated with this response; it is always initiated by a change at the EXT. MUTE input.

30

Advertising
This manual is related to the following products: