Nuvo NV-E6DMS User Manual
Page 29
COMMAND:
*ZxxVOLyy<CR> – Set volume of zone xx to level yy below max in dB from –0 to –78 dB
(include lead 0 for all single-digit values).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxVOL+<CR> – STARTS zone xx volume ramp UP at the rate of +10 dB per second in +1 dB steps.
(This is the same as holding VOLUME UP key on a KEYPAD for 1 second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND:
*ZxxVOL-<CR> – STARTS zone xx volume ramp DOWN at the rate of -10 dB per second in -1 dB steps.
(This is the same as holding VOLUME UP key on a KEYPAD for 1 second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND:
*ZxxVHLD<CR> – STOPS zone xx volume ramp initiated by *ZxxVOL+<CR> or *ZxxVOL-<CR> commands.
This results in a HOLD of the level at time of command receipt. RESPONSE: #ZxxVHLD<CR>
*********************************************************************************
COMMAND:
*ZxxMTON<CR> – zone xx MUTE ON (mutes currently connected source)
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxMTOFF<CR> – zone xx MUTE OFF (returns zone output to currently connected source at previous volume setting).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxBASSyyy<CR> – zone xx BASS EQ with yyy = EQ level, dB, –12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxTREByyy<CR> – zone xx TREBLE EQ with yyy = EQ level, dB, –12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxGRPON<CR> – zone xx SOURCE GROUP ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxGRPON<CR> – zone xx SOURCE GROUP ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxGRPOFF<CR> – zone xx SOURCE GROUP OFF.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP switches) for this zone until power is cycled.
29