Panasonic TU-HDS20 User Manual

Page 70

Advertising
background image

69

R

OLLER

G

UIDE

M

ENU

O

PERATIONS

Setup : Ant Setup – Auto Scan
The Auto scan allows you to retrieve all of the antenna or unscrambled cable channel.
When you press the ACTION key while the START button is highlighted, the
automatic scan of all available RF channels will begin. During Auto Scan mode only
the following commands will function:

Power Off (POWER key)

Stop auto scan (ACTION KEY)

GUIDE Key

The auto scan normally takes several minutes to complete. To inform the user that the
scanning is still in progress: the current channel being scanned, the current percent of
scan completed, and a bar meter is displayed, as shown in the figures below. If the
channel has been received, the channel number moves to the right and a “Received”
message is displayed. If no channels have been received after the scan is completed
a message will be displayed indicating that the auto scan has detected no channel
and that the user might want to check the input signal connections. Video will not be
present in the background during Auto Scan.

Procedure

H In the Ant Setup menu, press G button to highlight Auto Scan.
H Press K button and ACTION button to start Auto Scan. After completion of the auto scan,

press ACTION and press

J button to return to Sat setup.

H Press ACTION button to stop the Auto Scan if necessary.

G Ant Setup

Ant Input

Auto Scan

Add/Del Ch

Press

K to perform auto scan.

Scanning Channel

23

50%

Stop

Ant Setup Setup – Auto Scan

Advertising