Panasonic TU-HDS20 - Manual (Page 31)

30
G ETTING S TARTED
Step 2b. HDTV Digital Receiver connection to Conventional TV
Follow this diagram when connecting the HDTV Digital Receiver to a conventional TV
or Monitor. Terrestrial and digital signal can be received by connecting the digital
receiver to the TV or Monitor.
Procedure
• Select 480i mode by using the Video Out button on the front panel.
• Connect the RF OUT to the ANT IN of the television or connect video cable from the video
output jack on the HDTV Digital Receiver to the video input jack on the TV.
OR
• Connect S-VIDEO Cable from the NTSC S-VIDEO output jack on the HDTV Digital
Receiver to the S-VIDEO input jack on the TV.
Note: Connect either the S-Video or video input/output as shown above.
• S-Video will provide better picture quality.
• If both S-Video and video are connected, S-Video will override video.
• Connect audio cables from the left and right NTSC audio output jacks on the HDTV Digital
Receiver to the left and right audio input jacks on the TV.
Note: Modem should also be connected to a telephone jack using the supplied modem cable
if impulse pay per view services are desired.
CONVENTIONAL TV/MONITOR
DIGITAL
AUDIO OUT
(AC-3)
®
!
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
HDTV DIGITAL RECEIVER
R-AUDIO-L
NTSC OUTPUT
R-AUDIO-L VIDEO S-VIDEO
DIGITAL OUTPUT
H-SYNC-L
R B G
P R P B Y
DISTRIBUTED BY
MATSUSHITA ELECTRIC
CORPORATION OF AMERICA
ONE PANASONIC WAY,
SECAUCUS, NEW JERSEY 07094
ASSEMBLED IN MEXICO
TEL LINE
MODEL NO.
SERIAL NO.
AC 120V 60Hz
MAX AMPS
MANUFACTURED
RGB/YP
B
P
R
ANT IN
CH 3
CH 4
RF OUT SATELLITE
IN
TERRESTRIAL OR
CABLE ANTENNA
INPUT
ANT IN
VIDEO AUDIO S -VIDEO
R L NOTE: S-VIDEO AND VIDEO
CABLES NOT INCLUDED
HDTV DIGITAL RECEIVER
CONVENTIONAL TV SETUP
Connect the
S-Video or
video cable.
See Note
below.