Safety advice relating to cordless drill drivers, Before first use, Checking the battery status – Parkside PABS10.8-LI User Manual

Page 9: Changing tools

Advertising
background image

10 GB

Safety advice relating
to cordless drill drivers

½

Securely support the workpiece. A work-
piece held in a clamp or vice is kept more se-
curely in place than one held by your hand.

½

WARNING!

POISONOUS DUSTS!

Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area.

½

Wear safety glasses and a dust

mask!

½

Do not drill any material containing
asbestos. Asbestos is a known carcinogen.

½

Hold the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.

½

If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.

½

WARNING!

The inserted tool may

strike concealed electricity cables,
therefore when working you must
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.

½

Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.

©

Before first use

©

Removing / charging / inserting
rechargeable battery pack

Note: The battery is supplied partially charged.
Charge the battery in the charging station for at

least three hours before first use. By doing this the
battery will operate at its highest capacity. You can
charge the Li-Ion battery at any time without risk of
shortening battery life. Interrupting the charging
process does not damage the battery.

1. In order to remove the rechargeable battery pack

8

, press the release buttons

9

and take the

rechargeable battery pack

8

out of the device.

2. Place the charging cap

16

onto the rechargeable

battery pack

8

.

3. Place the power supply unit

13

into the socket.

The status LED

14

will shine red.

4. The green charge indicator LED

15

shows you

that the charging process is complete and the
battery pack

8

is ready for use.

5. Insert the rechargeable battery pack

8

into

the device.

©

Checking the battery status

˽

To check the battery status, press the button for

the rechargeable battery LED

2

(refer to main

diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED

3

as follows:

GREEN / RED / ORANGE = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery

©

Changing tools

Your cordless drill / screwdriver has a fully automat-
ic spindle lock

.

Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck

12

can

be opened simply by turning it

.

After you have inserted the required bit and fixed it
in place by turning the chuck

, you can immedi-

ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

6

).

General safety advice for electrical power tools / Before first use

Advertising