Chapter 2: product overview, Srw2048, Front panel – Linksys BUSINESS SERIES SRW224G4 User Manual

Page 9: Leds, Back panel, Front panel leds back panel, Chapter 2, Product overview

Advertising
background image

2

Product Overview

WebView Switches

Chapter 2

Chapter 2:
Product Overview

SRW2048

Front Panel

The Switch’s LEDs and ports are located on the front
panel.

Front Panel of the SRW2048

LEDs

POWER

(Green) Lights up green to indicate

that power is being supplied to the Switch.

LINK/ACT (1-48)

(Green/Amber) Lights up

green to indicate a functional 10/100-Mbps
network link through the corresponding port (1
through 48) with an attached device. It flashes
to indicate that the Switch is actively sending
or receiving data over that port. Lights up
amber to indicate a 1000-Mbps connection on
the corresponding port (1 through 48) with an
attached device. It flashes to indicate that the
Switch is actively sending or receiving data over
that port.

ETHERNET 1-48

The Switch is equipped with

48 auto-sensing, Ethernet network ports, which
use RJ-45 connectors. The Fast Ethernet ports
support network speeds of 10 Mbps, 100 Mbps,
or 1000 Mbps. They can operate in half and
full-duplex modes. Auto-sensing technology
enables each port to automatically detect the
speed of the device connected to it (10 Mbps,
100 Mbps, or 1000 Mbps), and adjust its speed
and duplex accordingly.

MiniGBIC (1-4)

The miniGBIC (gigabit interface

converter) port is a connection point for a
miniGBIC expansion module, so the Switch can
be uplinked via fiber to another switch. The
MiniGBIC port provides a link to a high-speed
network segment or individual workstation at
speeds of up to 1000 Mbps.

Use the Linksys MGBT1, MGBSX1, or MGBLH1
miniGBIC modules with the Switch. The
MGBSX1 and the MGBLH1 require fiber cabling
with LC connectors, while the MGBT1 requires
a Category 5e Ethernet cable with an RJ-45
connector.

NOTE:

On the SRW2048, MiniGBIC ports are

shared with standard ports. If a miniGBIC port
is used, then the shared standard port on the
Switch cannot be used. The following table
provides port mapping details of the SRW2048
Switch.

SRW2048 Shared Port Mapping

miniGBIC Port

Standard Port

miniGBIC 1

Port 23

miniGBIC 2

Port 24

miniGBIC 3

Port 47

miniGBIC 4

Port 48

Back Panel

The power port is located on the back panel of the
Switch.

Back Panel of the SRW2048

POWER

The Power port is where you will

connect the AC power.

Advertising