Linksys BUSINESS SERIES SRW224G4 - Manual (Page 57)

Chapter 5 Advanced Configuration
50 WebView Switches
Leave Timeout Indicates the amount of time the host
waits, after requesting to leave the IGMP group and not
receiving a Join message from another station, before
timing out. If a Leave Timeout occurs, the switch notifies
the Multicast device to stop sending traffic The Leave
Timeout value is either user-defined, or an immediate
leave value. The default timeout is 10 seconds.
Multicast > Bridge Multicast
The Bridge Multicast screen displays the ports and LAGs
attached to the Multicast service group in the Ports and
LAGs tables. The Port and LAG tables also reflect the
manner in which the port or LAGs joined the Multicast
group. Ports can be added either to existing groups or to
new Multicast service groups. The Bridge Multicast screen
permits new Multicast service groups to be created. The
Bridge Multicast screen also assigns ports to a specific
Multicast service address group.
Multicast > Bridge Multicast
The Bridge Multicast screen is divided into two areas,
Configuring Multicast and Multicast Table. The fields are
the same for both areas.
Enable Bridge Multicast Filtering Enables Bridge
Multicast Filtering.
VLAN ID Identifies a VLAN to be configured to a Multicast
service.
Bridge Multicast Address Identifies the Multicast group
MAC address/IP address.
Bridge IP Multicast Displays the port that can be added
to a Multicast service.
Interface or LAG Displays LAG that can be added to a
Multicast service.
The configuration options are as follows:
Static • The port is user-defined.
Dynamic • The port is configured dynamically.
Forbidden • Forbidden ports are not included the
Multicast group, even if IGMP snooping designated
the port to join a Multicast group.
None • The port is not configured for Multicast service.
Use the Add to List button to add the configured RMON
event to the Event Table at the bottom of the screen.
Multicast > Bridge Multicast Forward All
The Bridge Multicast Forward All screen contains fields
for attaching ports or LAGs to a device that is attached
to a neighboring Multicast router/switch. Once IGMP
Snooping is enabled, Multicast packets are forwarded to
the appropriate port or VLAN.
Multicast > Bridge Multicast Forward All
The Bridge Multicast Forward All screen contains the
following fields:
VLAN ID Displays the VLAN for which Multicast
parameters are displayed.
The configuration options are as follows:
None • The port is not configured for Multicast service.
Forbidden • Forbidden ports are not included the
Multicast group, even if IGMP snooping designated
the port to join a Multicast group.
Static • The port is user-defined.
Dynamic • The port is configured dynamically.