Troubleshooting – Kenwood Chef KM400 series User Manual

Page 5

Advertising
background image

troubleshooting

solution

1

2

3

4

5

6

1

2

3

4

5

6

problem

The whisk or K-beater knocks against the bottom of the bowl or isn’t
reaching the ingredients in the bottom of the bowl.
Adjust the height. Here’s how:

Unplug.
Raise the mixer head and insert the whisk or beater.
Hold it, then loosen the nut

Lower the mixer head.
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
be

almost

touching the bottom of the bowl

Raise the head, hold the whisk/K-beater and tighten the nut.

to fit and use your round/D-shaped
splashguard (if supplied)

Raise the mixer head until it locks.
Fit the bowl onto the base.
Push the splashguard on until fully located

. The hinged section

should be positioned as shown round

and D-shaped

Insert required tool.
Lower the mixer head ensuring the splashguard follows the shape of
the bowl.
During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard.
You do not need to remove the splashguard to change tools.
Remove the splashguard by raising the mixer head and sliding it down.

3

Advertising
This manual is related to the following products: