Klark Teknik DN9344E User Manual

Page 34

Advertising
background image

HELIX DN9340E/DN9344E Remote Control Software

User Guide


34 of 65

8

The Access Point SSID should now appear in the lower
Preferred Networks list. If necessary, move the network SSID
to the top of the list, using the Move up button, so that
Windows automatically connects to it in preference to

other available networks.

9

Highlight the SSID in the lower list and click Refresh in the
upper panel. After one or two minutes, (depending on

signal strength and quality), Windows should pop up a

notification box to show that it has found a new network.

The SSID should now appear in the upper Available Networks
list, with an active transmitter symbol (as shown).

If the Access Point SSID is not yet visible in the Available
Networks
list, refer the Help box below.

10

Click OK to exit the dialogue box.

The Access Point SSID may take some time to register in the Available Networks list, as the Access
Point must complete a re-boot to effect the configuration changes. Try refreshing again but this
time exit the dialogue box by clicking OK. Wait at least two minutes to ensure the Access Point
re-boot has had time to complete, and then re-open the Wireless Network Connections

Properties dialogue box.

If the SSID still does not appear, open up the Network Connections window from the Control
Panel and ensure that the wireless connection is shown and not disabled. If it is correctly

enabled and you cannot make the connection, refer to your wireless hardware equipment

manuals for help.

Help

Advertising
This manual is related to the following products: