Klark Teknik DN9344E - Manual (Page 25)

HELIX DN9340E/DN9344E Remote Control Software
User Guide
25 of 65
5 Choose Apply to apply the changes and keep the screen open for further copying.
or
Choose OK to apply changes and close the screen.
Note If you see the following message,
this feature is not available as
there are lock flags active.
If copying basic settings to most channels, use Select All to tick all channels in the destination
list, then clear check boxes as required. When starting a new selection, use Reset All to quickly
clear all previous ticks.
6.4 Global Graphic Screen
The Global Graphic screen, accessed from the Global Graphic button in FastNav ® , has 31 fader controls.
These faders provide global gain adjustment of the 31 bands of the 1/3 octave equaliser across all
channels and correspond to the ones found on the Graphic Equalisation view, accessed from the Graphic
tabs.
Operation of a fader on the Global Graphic screen causes the corresponding fader on all channels to be
adjusted by the same amount. For example, if you adjust the 100k fader on the Global Graphic screen
by +8dB, then each channel’s 100k fader will be increased by +8dB. This is irrespective of the position
of the channel faders before adjustment. However, if a channel fader is at or near its maximum or
minimum value it may not be able to accept the full amount of adjustment; in this case it will be
adjusted to maximum or minimum.
Once selected, the Global Graphic screen remains on top of the other ELGAR screens and operation is
restricted solely to the Global Graphic faders. Changes to these faders are reflected in the graphs on
the Home, Graphic and Memory screens, and also the Graphic’s faders. You can reposition the Global
Graphic screen (see diagram below) to view more easily what is underneath, but to edit the other
ELGAR screens you must close the Global Graphic screen first by clicking on the Close button.
Hint