4 filters – Klark Teknik DN9344E User Manual

Page 20

Advertising
background image

HELIX DN9340E/DN9344E Remote Control Software

User Guide


20 of 65

To switch a Dynamic section out of the circuit

1

Tick the † Out check box at the bottom
right-hand corner of its Dynamic control

panel.

The Dynamic is faded to grey on the graph and

its contribution is removed from the overall

frequency response. The target remains active
so that it can still be adjusted while switched

out.

2

To switch it in again, clear the check box.

5.4 Filters

To switch to the Filter view

Click on the Filter button of the Channel A or B Navigation Strip, as required. (If staying on
the same Channel, you may prefer to click on a Filter tab).

The upper Filter Mode tab is used to set the bypass state and the Graph display mode (when a DN9340)

for the current channel. The lower Filter Shaping tab provides a control panel for each added Filter.
Filter settings can also be adjusted at the display by using the target cursor.

Dynamic
switched out

The black graph
shows overall
response. The
red graph shows
the response of
the selected LO
or HI Dynamic

The Filter freq,

level, and Q are

adjusted by

dragging the

‘target’ or

setting values

Tick the check box to switch
the filter out of the circuit

Filter Mode tab

Choose a notch, pass

or shelf filter

Filter Shaping

tab

Control panels

appear as you

add Filters

Advertising
This manual is related to the following products: