Klark Teknik DN9344E - Manual (Page 18)

HELIX DN9340E/DN9344E Remote Control Software
User Guide
18 of 65
5.3 Dynamic Equalisation
To switch to the Dynamic Equalisation view
Click on the Dynamic button of the Channel A or B Navigation Strip, as required. (If staying
on the same Channel you may prefer to click on a Dynamic tab).
The upper Dynamic Mode tab is used to set the characteristic of the Threshold Dependent Dynamic EQ
( T-DEQ), bypass state and graph display mode (when a DN9340) for the current channel. The lower
Dynamic Shaping tab provides a control panel for each of the two Dynamic EQ sections that can be
applied to the frequency response. The Dynamic EQ sections can also be adjusted at the display by
using the target cursor.
To set the Dynamic EQ mode for the channel
1 Select a Proportional, Constant or Symmetrical Q
characteristic from the EQ Type drop down
menu.
2 Use the Unit Display drop down menu to set the
Dynamic EQ display mode that DN9340 units
should assume when taken out of slave
operation; this only comes into effect if the slave
is a DN9430. The choice made here has no
effect on your AddIn device display.
Note Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes
and Q.
The black graph
shows overall
response. The
red graph shows
the response of
the selected LO
or HI Dynamic
The Dynamic
section’s freq,
level and Q are
adjusted by
dragging the
‘target’ or
setting values
Dynamic Mode
tab
For a shelf
dynamic, choose
an EQ slope
Tick the check box to switch the
PEQ section out of the circuit