Klark Teknik DN9344E User Manual
Page 15
HELIX DN9340E/DN9344E Remote Control Software
User Guide
15 of 65
2
To apply autogain, tick the AutoGain check box and type in (or scroll) the required value in
the field below.
3
Use the Unit Display drop down menu to set the Graphic display mode that DN9340 units
should assume when taken out of slave operation; this only comes into effect if the slave is
a DN9430. The choice made here has no effect on your AddIn device display.
To Bypass the graphic EQ on the current channel
Tick the Bypass check box in the upper tab.
To adjust a fader level
To help fader selection at the graph, the frequency band and dB level is displayed as you hover
over a fader.
Click and drag the fader on the graph or on the lower tab. The graph and tab faders are
linked so that they move simultaneously.
The overall frequency response (black line) updates as you adjust the fader. The individual response of
the fader is also shown (in red) while the fader is selected.
To adjust a group of faders together
1
Click and drag the cursor diagonally over the group of
faders to enclose them in the selection box. The selected
faders are highlighted in red.
2
Click and drag any of the selected faders to move the
whole group up or down by the same dB while retaining
their relative values.
3
To deselect the group, click anywhere on the graph outside
the group.
The overall frequency response (black) updates as you adjust the
group. The individual response (red) is only shown for the fader that you drag. If required, the
response of the other faders can be checked by clicking on each one in turn.
To reset all faders to zero
Click on the All Flat button in the Global Graphic tab.
To switch a fader out of the circuit
1
Tick the check box directly beneath the fader in the
lower tab.
The fader response is faded to grey on the graph (the
setting is retained for recall) and its contribution is
removed from the overall frequency response.
2
To switch the fader in again, clear the check box.
Fader In
Fader Out
Hint