Klark Teknik DN9344E - Manual (Page 14)

HELIX DN9340E/DN9344E Remote Control Software
User Guide
14 of 65
5 P
ROGRAMMING
EQ
5.1 Graphic Equalisation
To switch to the Graphic Equalisation view
Click on the Graphic button of the Channel A or B Navigation Strip, as required. (If staying
on the same Channel, you may prefer to click on a Graphic tab).
The upper Graphic Mode tab is used to set the EQ type, bypass state, autogain etc. for the current
channel. The lower Graphic Shaping tab provides 31 fader controls for adjusting the gain of the 31
bands of the 1/3 octave equaliser; these are mirrored by fader controls along the frequency response
graph.
To specify the EQ mode for the current channel
1 In the upper tab, open the EQ Type drop down
menu and select Proportional, Constant, or
Symmetrical Q. Type in or scroll to the required Q.
or
Select a Klark Teknik DN360 or DN27 emulation
curve from EQ Type drop down menu. The Q field
is disabled for the emulations.
Note Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes
and Q.
Faders can
be adjusted
on the graph
or on the tab
Use the All Flat button
to reset all faders
Graphic Mode
tab
The black graph
shows combined
EQ. The red
graph shows the
response of the
selected fader
Tick the fader
check box to
switch it out
Graphic
Shaping tab