Sunbeam EM8910 - Manual (Page 41)

• <<PLEASE WAIT>>
The coffee brewing unit is positioned.
• <<WASTE CONTAINER UNDER
STEAM WAND>> – press “OK”
Remove and empty the coffee waste
container. Place the emptied coffee waste
container under the steam wand, see figure
62. Then press the “OK” button.
Note: The container serves as a collecting
vessel for the descaling solution.
• <<OPEN STEAM SWITCH>>
Turn the selection dial for the steam and
hot water functions to the setting. The
descaling program starts. See figure 63.
Note: During the descaling program the
display shows the following indications
alternately:
• <<DESCALING CYCLE>>
The program carries out 14 rinses. The
pauses allow the descaling solution to take
effect. The rinsing cycles are counted off in
the display.
• <<IN PROGRESS>>
The bar indication in the bottom line
increases with the advance of the pause
duration.
The display shows the following at the end of
the last rinsing:
• <<CLOSE STEAM SWITCH>>
Turn the selection switch for the steam and
hot water back to the off position. See figure
64.
• <<EMPTY WASTE CONTAINER>>
– Press “OK”
Empty the coffee waste container. Then press
the “OK” button.
• <<WASTE CONTAINER UNDER STEAM
WAND>>
– press “OK”
Place the emptied coffee waste container
under the steam wand. Then press the “OK”
button.
• <<RINSE AND REFILL WATER
RESERVOIR>> – press “OK”
Remove the water reservoir, rinse it
thoroughly, fill with fresh water and replace.
Then press the “OK” button.
The espresso machine is now ready to be
rinsed with fresh water.
• <<OPEN STEAM SWITCH>>
Turn the selection dial for the steam and hot
water functions to the setting. A rinsing
with fresh water is carried out.
• <<RINSING PLEASE WAIT>>
• <<CLOSE STEAM SWITCH>>
39
Running the descaling program (continued)
Figure 63 Figure 64