Running the cleaning program – Sunbeam EM8910 User Manual

Page 38

Advertising
background image

The cleaning program allows complete
removal of coffee oils even in areas which are
not normally accessible. Start the cleaning
program at the latest when you are instructed
by the display indication
<<CLEANING REQUIRED>>.
The cleaning process takes about 8 minutes
and should not be interrupted. If it is
interrupted the cleaning process has to be
started again.
Important: Prior to starting the cleaning
program, clean the coffee brewing unit and
empty the coffee waste container. Refill the
water reservoir with approximately 1 litre of
fresh water.
Important: Use the Sunbeam ‘Cleaning’
tablets only. If using other cleaning agents,
Sunbeam will not be liable for any damage.
Sunbeam cleaning tablets are available from
selected appliance retailers or from Sunbeam
on 1800 025 059.
• Press the “MENU” button. The menu

setting <<LANGUAGE>> appears.

• Press the scrolling buttons

or ▼ until

the menu setting <<CLEAN >> appears.

• Confirm the menu setting by pressing the

“OK” button. The display shows
<<START CLEANING>>.

• Confirm with the “OK” button. The display

shows <<CLEANING INSTRUCTIONS>>.

Important: To prepare for cleaning, follow the
instructions on the display then press “OK”
to confirm that you have done so.
• <<REFILL WATER RESERVOIR>>

– press “OK”

Remove the water reservoir, fill it with water
and replace. Then press the “OK” button.
• <<BEAN HOPPER TO PRE-GROUND>>
Note: This message only appears when the
bean hopper is in whole bean mode.

Turn the bean hopper to the pre-ground
coffee position, see figure 58.

36

Running the cleaning program

Figure 58

Figure 59

Figure 60

Advertising