Sunbeam EM8910 - Manual (Page 24)

22
Milk texturing is the steaming of milk to heat
it and to create froth. Similar to making an
espresso, perfecting the art of milk texturing
takes time and practice.
• Use fresh, cold milk and fill a stainless
steel frothing jug to no more than ¹/³ full.
• The amount of milk you steam should be
adequate for the coffees you are preparing.
Keep in mind that the volume of milk will
increase or ‘stretch’ during the texturing
process.
• Once you have activated the steam and
inserted the steam nozzle into the jug,
position the steam arm 1½ cm from the
side of the jug with the tip of the nozzle
just below the surface of the milk. The
jug needs to be at a slight angle with the
steam arm resting on the spout of the jug.
This will create a whirlwind motion in the
milk.
Note: You should hear a hissing sound. If you
are creating large bubbles, raise the jug so
that the nozzle tip is lowered deeper into the
milk.
• As the steam heats the milk, the milk will
begin to rise. Follow the level of the milk
by lowering the jug, always keeping the tip
of the steam nozzle just below the surface.
• Once the milk has stretched to double its
original volume, lower the steam nozzle
further into the milk and continue to heat
the milk. This will give the milk a fine
texture and not a mass of large aerated
bubbles.
• Cease steaming when the frothing jug
becomes too hot to hold your hand against
it.
• With the frothing jug in hand, swirl and tap
the jug until the milk becomes shiny and
no bubbles remain, this ensures an even
consistency. Pour the textured milk into
your espresso as soon as possible.
Frothing with the frothing attachment
If you are just learning to texture/froth
milk you may find it initially easier using
the frothing attachment packed with the
Sunbeam Intuitive Digital. Once you have
had some practice in texturing/frothing
milk, we recommend not to use the frothing
attachment as you will have greater control of
the texture and temperature of the milk.
• Attach the frothing attachment to the
steam arm.
• Once you have activated the steam,
insert the steam arm with the frothing
attachment into the jug. Position the
steam arm 1½ cm from the side of the jug
with the frothing attachment completely
immersed in the milk, so the tip of the
frothing attachment is held just above the
base of the jug.
• Hold the frothing attachment in this
position until the milk has stretched to
double its original volume. Cease steaming
when the frothing jug becomes too hot to
hold your hand against it.
Important cleaning instructions for the steam
nozzle
The steam nozzle needs to be cleaned each
time you steam milk. To clean the steam
nozzle, wipe with a damp cloth.
Note: Should the steam nozzle become
blocked, using a pin or a thin wire, insert it
into the hole in the base of the steam nozzle.
Note: When using the frothing attachment,
after use remove from the steam arm and
clean with hot soapy water to prevent the
build up of dried milk.
Easy steps for frothing milk