Sunbeam EM8910 - Manual (Page 14)

12
Prior to first use the Sunbeam Intuitive Digital
should be adjusted to the relevant degree of
water hardness for your region. Water hardness
refers to the mineral content of your local water
supply. You may determine the hardness degree
using the supplied test strips.
Determining water hardness
• Dip the test strip into cold water for 1
second. Shake off the excess water and
the degree of water hardness is determined
according to the number of pink-coloured
squares.
Hardness degree
1 2 3 4
soft medium hard very hard
Test strips
Setting and saving the water hardness level
You can set 4 hardness levels. The Sunbeam
Intuitive Digital is factory set to hardness
level 3.
• With the machine switched on, press the
"MENU" button.
LCD: Indicates <<LANGUAGE>>.
• Press the scrolling keys
▼
or ▼ until the
LCD indicates <<WATER HARDNESS>>.
See figure 10.
• Confirm your selection by pressing the "OK"
button. See fugure 11.
LCD: Indicates current setting eg.
<<HARDNESS LEVEL 3>>
• Then press the scrolling keys
▼
or ▼ until
the desired hardness level is displayed.
See figure 10.
• Confirm the selection with the "OK" button.
See figure 11.
Note: After programming the LCD returns
automatically to the menu point
<<HARDNESS LEVEL 3>>
• To return to normal operating mode, press
the "MENU" button.
Note: If you have not made a selection within
30 seconds the machine automatically
returns to the normal operating mode.
Setting the water hardness
Figure 10 Figure 11