SINGER 14SH654 - Manual (Page 3)

Photo #1
Step 3:
Threading Lower Looper: (YELLOW)
• Slip the thread behind the first guide directly below
the tension dial from right to left.
• Slip thread behind the 4 yellow thread guides (these
are indicated by yellow dots below the guide).
• Slip thread behind the lower looper using the
tweezers as shown in photo #2, until the thread slips
into the notch located at the far left on the looper.
• Next thread the eye of the looper, and then pull the
thread over the top of the upper (orange) looper and
then towards the back of the serger, leaving
approximately 8 inches of thread.