Adjustments, Neutral adjustment hydro, Forward speed hydro – Simplicity 1692969 User Manual

Page 26

Advertising
background image

Adjustments

View is from right side of tractor

with rear wheel removed.

Figure 20. Neutral Adjustment Hydro Model
A. Nut

C. Cam Slot

B. Neutral Adjustment Rod

D. Stop Pin

NEUTRAL ADJUSTMENT HYDRO

If the tractor creeps forward or backward with the engine
running and both travel pedals released, perform the fol-
lowing adjustment:

1. Raise the rear of the tractor off the ground with suit-

able hoist or floor

jack.

Install jackstands underneath

the

and block the front wheels.

2.

Start

the engine and release the parking brake while

keeping seat switch depressed.

3. See figure 20. Loosen the nut (A) securing the neu-

tral adjustment rod (B). Move the rod until neutral is
found, then retighten the nut.

4. The stop pin (D, figure 20) should be positioned

from the end of the cam slot (C, figure 20) as

shown when the front pedal edge is

above the

frame (pedal fully depressed). If it is not, proceed to

the Forward Speed Adjustment procedure below.

FORWARD SPEED

HYDRO

If the unit

does

not reach top speed with the forward

direction pedal fully depressed, perform the following
adjustment with the engine off and PTO disengaged.

1. See figures 21 a

21 b. Loosen the nut (A, figure 21 a)

securing the control rod (B) to the hydro control lever.

NOTE: Hydro control rod

should be on the inside of the

control lever(C). the rod is not in

remove the hardware, reposition the

as

2. Position the pedal so the distance between the frame

and bottom edge of the pedal is

as shown in

figure 21 b.

3.

pedal in this position, tighten the nut (A, figure 21a).

4. The stop pin (D, figure 20) should be positioned

to

the end of the cam slot (C, figure 20) as shown

Figure 21a. Forward Speed Adjustment Hydro

A. Bolt

C.Hydro Control Lever

B. Control Rod

Figure 21 b. Forward Speed Adjustment Hydro

Figure 22. Neutral Adjustment Gear Model

A. Hardware

B. Shaft

2 2

Advertising
This manual is related to the following products: